Vertical milling machine operation precautions

vertical milling machine

Milling machines, we all know that there are many types, such as vertical milling machines, horizontal milling machines, bed-type milling machines, etc., we will not introduce them one by one.

Compared with horizontal milling machines, the vertical difference between the vertical milling machine and the vertical milling machine is the vertical arrangement of the spindle, which is widely used in various CNC machine tool industry fields! Because vertical milling machines are suitable for machining large flat surfaces and using various shank milling cutters to machine grooves and step planes, what should we pay attention to during use?

The vertical milling machine operation notes are as follows:

  • Before using the vertical milling machine, it must be carefully inspected according to the inspection point and lubricated according to the lubrication chart.
  • If the vertical milling machine is deactivated for more than eight hours and then the equipment is started, it should be rotated at a low speed for three to five minutes to confirm that the lubrication system is smooth and the movements of the various parts are normal before starting work.
  • During the use of the vertical milling machine, it is not allowed to leave and entrust others to take care of it. It is not allowed to remove the safety protection device, and it is not allowed to disassemble the gear.
  • If the vertical milling machine should be repaired, first loosen the fastening screws before moving the beam spindle table and lifting table, remove the surrounding debris, and then clean the guide rail and oil.
  • When the vertical milling machine is fast or automatic feeding, the limit gear should be adjusted first.
  • The equipment and the operation and lubrication of each department must be checked frequently during work. If it is running or poorly lubricated, stop using it.
  • Work surface bans, card gauges and workpieces.
  • When adjusting the automatic cycle, you must check the correctness of the automatic cycle of the machine before driving.
  • Work is completed. Place the handles of the vertical milling machine in the non-working position, the work table is placed in the middle position, the lifting platform falls below and the power is cut off.
  • It is strictly forbidden for the operator to overload the vertical milling machine.

Leave a Reply

Your email address will not be published. Required fields are marked *

Post comment

Share this news with others

Share on facebook
Facebook
Share on twitter
Twitter
Share on linkedin
LinkedIn
Share on pinterest
Pinterest
Share on email
Email
Share on print
Print

News Category

Recent News

Register Our Newsletter

Meekare will only send you e-mail when we have updated news, will not send you e-mail at any other time.